fig.
6.3 neck- click for a larger view
|
The
next step is to make the neck,
the front pillar, and the projecting block.
For
these, the best plan is to make templates in plywood taken from your
full size drawing.
fig.
6.3 pillar - click for a larger view
|
On
the template for the neck mark the position of the tuning pins and
bridge pins.
With
a 2mm bit, drill through all marks in the template; this will be very
useful later as a jig for making the drilling positions on the neck.
Note
that all drilling should be done before attempting any carving.
